A brief introduction to the basic structure of the rotary tablet press

Rotary tablet press can be used as a small brush, carbon, contact forming equipment The power part is mainly composed of output, transmission part and working part The working part consists of three parts: one is rotating around the axis, and the other is divided into three layers The upper part of the machine is equipped with punching up, the middle part is equipped with die ring, and the lower part is equipped with punching down; in addition, the fixed up and down pressing wheel, sheet weight regulator, pressure regulator, feeder, scraper, push sheet regulator, powder suction device and protective device, etc The machine is mounted on the central axis of the machine and rotates around the axis The upper part of the machine moves up and down regularly along the fixed up and down tracks The down and down tracks move up and down as well The upper pressing wheel and the lower pressing wheel are installed at the appropriate positions above and below the upper punching When the upper punching and the lower punching rotate and pass through the respective pressing wheel, they are pushed by the pressing wheel to make the upper punching move downward, and the lower punching move upward and pressurize There is a fixed position scraper on the middle layer of the machine The outlet of the fixed position feeder is aligned with the scraper The material can flow into the scraper continuously, and then into the die hole The pressure regulator is used to adjust the height of the lower pressure wheel If the position of the lower pressure wheel is high, the lower impact will be raised high during compression If the distance between the upper and lower impact is close, the pressure will increase, otherwise, the pressure will be small The sheet weight adjuster is installed on the down punching track to adjust the height of the down punching when it passes through the scraper to adjust the volume of the die hole.