A brief introduction to the internal and external circulation emulsifier installation and commissioning.

internal and external circulating emulsifier is a necessary equipment for paste productsSimple structure, easy to operate, reliable performance, is pharmaceutical, biological, cosmetics, chemical, food, petroleum, daily production of the ideal for customersthe following small section of a brief introduction on how to debug the installation of internal and external circulating emulsifier, as follows:1vacuum pump strictly prohibited without working fluid operationIt is strictly forbidden to clog the exhaust port while the pump is running.2Keep the homogenizer cleanEach time you stop using or replacing materials, the contact portion of the homogenizer should be cleaned, in particular the cutting wheel cutting sleeve of the head, the sliding bearings in the homogenous bushing and the bushingAfter cleaning and reassembly, the hand-turned impeller should be no cataging phenomenon, the pot body and the pot cover two flanges relatively fixed after the point-moving homogenizer motor turned correctly, no other abnormalities, before the operation can be started.3The vacuum pump can start operation under the sealing condition of the homogenous panIf there is a special need to open the atmosphere to start the pump, the operation can not be more than 3 minutes.4 Homogenic cutting, scraper stirring: after feeding (when debugging, you can replace water) and then open the corresponding control switch to control the operation of the homogenizer and the operation of the scraper stirring Before stirring start should also be ordered, check the stirred scraping wall for abnormal, if any should be immediately excluded .　　5 Before vacuuming work, we must check whether the pot is flat with the lid, the pot mouth, the material cover, etc is strict, sealed reliable Close the valve interface on the lid, then open the vacuum valve on the lid of the pot, then open the vacuum pump vacuum, after the requirements to close the vacuum pump, while closing the vacuum valve .　　6 Turn on the power supply, the power supply conforms, and pay attention to the reliable grounding of the ground, turn on the total power switch, the power led is on (The motor is wired or if it does not need to be re-used for a long time should be a bit of a test turn, the mixing frame turn to look from top to bottom as reverse.) When debugging, you should start with a tap stirring test turn, and let the homogenizer run when you confirm that it is correct .　　7 Properly connect the pipes of the homogenous pot (including the overflow, discharge and sewage, etc.) .　　8 Regularly check the parts and bearings of the lubricant and grease, timely replacement of clean lubricants and grease through the above content, I hope to understand the internal and external cycle emulsifier is helpful .