Analysis of what to pay attention to when using the labeling machine

The automatic labeling machine has the functions of product counting, output setting, parameter memory, automatic shutdown of equipment failure, alarm to indicate the fault location and help to establish information, etc.
It is suitable for flat bottles, square bottles, round bottles, etc.
, mainly used in food, daily chemicals , chemical, medical and other industries
.

The automatic labeling machine adopts a turntable centralizing roller mechanism controlled by a servo motor to ensure a high-precision circumferential positioning and labeling effect; it is designed for the irregular surface of the material and the curved bottle body to ensure the labeling accuracy and effect
.

The double-sided labeling machine can choose the detection electric eye of the transparent label to improve the detection accuracy
.


What should be paid attention to in the use of the automatic labeling machine: 1.
The speed of the glue pump should be kept relatively uniform.
If the speed is too slow, the glue may be broken and the labeling may not be firm or cannot be applied; There are air bubbles in the glue, resulting in uneven gluing, resulting in poor labeling or air bubbles after labeling, and the surface of the label is not smooth and bulging
.

2.
Control of the thickness of the glue layer If the glue film is too thick, the label fixing time will be extended accordingly and the displacement phenomenon will easily occur.
At the same time, the amount of the label glue will be increased, resulting in waste, and the label surface will appear due to the excessive amount of local glue There are bumps, the labeling is not smooth after labeling, or there is a phenomenon of "smearing"
.

However, the glue film is too thin, which will cause the labeling to be weak and the label to fall off
.

Generally speaking, the thinner the thickness of the glue film, the better without affecting the firmness of the label, which can be achieved by adjusting the distance between the rubber squeegee and the rubber roller
.

It is generally believed that the thickness of the ordinary paper label glue film (in casein) should be about 0.
015mm
.

The thickness of the aluminum foil should be between 0.
02 and 0.
03mm
.

 　　3.
The cleanliness of the label Under the premise of ensuring that the wear of the label does not affect the production, the label should be clean and clean, and no whole or damaged trademark paper should be pasted on it, so as not to affect the coating of the glue; the stripes of the glue palm should be fine, Uniform and clear, so that the glue can be applied as evenly as possible to ensure the quality of the labeling
.