Application of ultrasonic titanium rod filter cleaner

Titanium rod filter element is made of high-purity titanium and titanium alloy irregular powder It is mainly used in separation and filtration in petrochemical, liquid medicine manufacturing, water treatment and other industries Since it is separation and filtration, it is also valued in cleaning Therefore, Jining Tianhua ultrasonic equipment Co., Ltd has developed this titanium rod filter element ultrasonic cleaner It can easily clean the dirt on the surface of titanium rod filter element, bend, blind hole and so on, so that you can say goodbye to the trouble of dirt The cleaning process of Tianhua ultrasonic titanium rod filter element ultrasonic cleaning machine is divided into rough cleaning and fine cleaning Here is a detailed introduction of some operating procedures for ultrasonic cleaning machine of titanium rod filter element: 1 Rough cleaning (1) first place the ultrasonic cleaning machine, first place the "automatic / manual" switch in the manual position, close the water inlet and air inlet solenoid valve switches, and the rough cleaning time is about 5-10 minutes (2) after * times of washing, turn off the ultrasonic switch and open the drain valve to drain the polluted water, then refill the ion water to the overflow position and wash for 3-5 minutes After the rough washing, the filter element is basically purified If it is required to be strict, a rough washing shall be carried out 2 Fine washing (1) ultrasonic manual fine washing 1 Remove the filter element after rough washing, install the prepared tooling (different tooling for different models of 10 inches and 20 inches), and place the filter element in the cleaning tank one by one 2 Turn on the ultrasonic switch and motor rotation switch; turn on the external water inlet switch for internal and external recoil; if there is external purified air, turn on the air inlet switch (as the role of filter element to accelerate cleaning and drying), and the fine cleaning time is about 1-3 minutes (2) ultrasonic automatic fine cleaning 1 Before power on, turn the "automatic / manual" switch to the automatic position and the water inlet switch to the off state; * time relays control the cleaning time; the second time relay controls the water inlet, air inlet and circulation time 2 Set the cleaning time and intake air circulation time, pull out the filter elements after the rough cleaning, and install the prepared tooling (different tooling for different models of 10 inches and 20 inches) to place the filter elements in the cleaning tank one by one 3 Turn on the power, turn on the ultrasonic switch and the motor rotation switch, adjust the "automatic / manual" switch to the automatic position, open the intake solenoid valve of the water inlet solenoid valve alternately according to the set time, and recoil the filter element inside and outside for 7-8 minutes.