Automatic filling machine manufacturers summarize the problems easy to encounter in use

The automatic filling machine manufacturers summarize the problems that are easy to encounter in use Most of the automatic filling machine manufacturers are widely used in the food, medicine and daily chemical industries Due to the variety of products, however, if there is a fault in the production, it will bring about an undeniable impact on the production Therefore, enterprises should know more about the possible situation of machinery and how to deal with it Can guarantee the filling machine more, high quality, low-cost production The automatic filling machine manufacturer summarizes the problems that are easy to encounter in use: 1 The filling volume of the automatic filling machine manufacturer is not accurate or does not discharge 1 Whether the speed throttle valve and filling interval throttle valve are closed, and the throttle valve cannot be closed 2 Check whether there is any foreign matter in the quick mounting three-way control valve If so, please tidy up Check whether there is air in the quick mounting three-way control valve and the skin tube of the filling head If there is air, try to reduce or sweep the air 3 Check whether all sealing rings are damaged If there is any damage, please replace them with new ones 4 Check whether the filling nozzle valve core has jamming appearance or delayed opening If there is jamming, install the valve core from the beginning If it is delayed to open, it is necessary to adjust the thin cylinder throttle valve; 5 The spring force of the upper and lower tightening spiral spring in the quick installation three-way control valve will not open if the spring force is too large; 6 Whether the filling speed is too fast, adjust the filling speed throttle valve to reduce the filling speed; 7 Whether the cutting clamp and the leather pipe buckle can be sealed well, please correct if there is any; 8 If the magnetic switch is loose, please lock it after each adjustment 2 There are the following reasons for the material of the filling machine from the rear end of the cylinder: 1 Whether the cylinder is in the central position of the cylinder support, and if there is any change in the cylinder, please install it from the beginning; 2 Whether the cylinder piston and the piston rod are fastened, and if they are loose, please lock them; 3 Whether the O-ring of the cylinder piston is damaged, and if it is damaged, please replace it 3 After the piston of the material cylinder of the automatic filling machine manufacturer is pushed to the top, it does not return to the position of the movable magnetic switch Press the emergency stop switch and adjust the movable magnetic switch from the beginning