Characteristic structure and performance of salt spray corrosion test chamber

The salt spray test box is also known as salt spray corrosion test chamber and spray salt spray testing machine The equipment which can simulate the salt mist dispersion environment composed of small salt droplets in the atmosphere is widely used in electrical engineering, automobile, electronics, mobile phone communication, electronic components, motorcycles, machinery and other parts, plastic, aviation, metal material surfaces, and salt mist corrosion test of the whole or protective layer Structural features: drug testing supplement barrel: concealed attached water level gauge, German PVC gray impact plate, 5mm thick, integrated with the machine appearance The equipment consists of chamber, chamber heating, humidification system, saturation system, electrical control system, air supply system, protection system, etc Laboratory upper cover: made of transparent European temperature resistant acrylic plate, with thickness of 5mm Constant temperature water tank: adopt German PVC gray temperature and impact resistant plate, with a thickness of 6mm, and equipped with an automatic water level controller, avoiding the need of artificial water Laboratory backboard: PVC gray temperature resistant angle material is adopted, and the test angles of 15O and 30o can be adjusted freely Laboratory: adopt German PVC gray temperature and impact resistant board with thickness of 6mm If the test piece is placed at an angle of 30 degrees, 15 pieces can be placed If the test piece is placed at an angle of 15 degrees, 20 pieces can be placed Note: the size of the test piece is 150 × 70mm (H × d) saturated air bucket: it is made of stainless steel plate, with a thickness of 2mm, and is attached with an automatic water level controller, so as to avoid the inconvenience of adding water manually The outside of the box body is equipped with a graduated liquid separation pipe, which can measure the settlement of salt mist, and the measurement is clear at a glance A water sealing groove is arranged between the cover of the equipment box and the box body, which has good air tightness and a water discharging device The bottom of the working room is equipped with a water retaining ring and the middle is an overflow port, which can not only maintain a certain water level, prevent the box from aging, but also discharge the excess water out of the box.