Common faults and solutions of pelletizer

To eliminate the causes of the common faults of the pelletizer, the following operations can be carried out only after the power supply is cut off: 1 After the machine is powered on, the motor does not operate The causes are: (1) poor contact of the power line or loose power plug; (2) poor contact of the switch Solutions: (1) repair the power supply or replace the plug with the same specification; (2) repair or replace the switch with the same specification 2 When the machine-made pill is used, the axis knife rotates or the discharging baffle of the drug surface sticking groove is loose, which has a distance from the bottom of the axis knife, so the pill cannot be scraped off from the axis knife groove Adjust the distance between the discharge baffle and the bottom of the shaft knife slot (about 0.1mm) and tighten the fixing screw 3 When the machine is working, the motor stops suddenly The reasons are as follows: (1) the capacitance is open circuit (2) Gear stuck Solution: (1) go to the maintenance department of the local office, and have professional personnel for maintenance (2) Check the gear groove for sundries and clean it 4 When the machine is working, the shaft cutter does not rotate, the shaft cutter box is not aligned with the gear, and turn the shaft cutter gently by hand until the gear is aligned and clamped in place 5 The machine generates abnormal noise during operation Causes: (1) the friction part between the shaft cutter and the body is dry and oil-free; (2) there is no oil between the gears Solution: (1) pour several drops of clean edible oil into the oil hole; (2) apply a small amount of butter to each gear groove, and add oil into the oil hole; 6 Heater heating failure Causes: (1) the plug is loose or the power cord is off (2) Heater heating wire is blown Solution: (1) replace the plug of the same specification or repair the power socket (2) Go to the maintenance department of the local office and have the maintenance carried out by professionals.