Common knowledge of paint: common problems and precautions in wood paint construction

Key tips: common problems in wood paint Construction: 1 Wet foaming, high paint viscosity 2 Impurities are mixed into the granulation, and the paint has solidified 3 Excessive cracking and thick coating, incomplete drying between coatings 4 The undercut bottom layer is too thick and does not dry completely, and the bottom and top coat are not matched 5 The paint on the upper and lower layers falls off, and the base material is not polished 6 One time thick coating with flow hanging, short recoating time and low viscosity of coating matters needing attention: 1 The wood paint shall be brushed after the completion of the ground construction During the construction, the ventilation shall be kept and there shall be no dust, so as to avoid affecting the overall effect The wood paint and emulsion paint cannot be applied at the same time Shenyang steel structure fireproof coating construction expert punde Building Fire Engineering Co., Ltd Recommended introduction: since its establishment, Shenyang punde Construction Fire Engineering Co., Ltd has cultivated a group of professional construction teams with excellent equipment, rich experience and serious responsibility with advanced and scientific management methods and strict engineering quality assurance and after-sales service system It has undertaken a number of fire system installation projects, which has been praised by customers Every idea and special requirement of you will be fully considered by us and fully realized in the construction technology, which will become the cornerstone of our successful long-term development We are looking forward to your invitation, to provide you with quality services and high-quality technical support! All construction coatings have passed ISO9001 Paint Home News: common problems in wood paint Construction: 1 Wet blistering, high paint viscosity 2 Impurities mixed with lifting particles, paint has been cured 3 Excessive cracking and thick coating, incomplete drying between coatings 4 Too thick undercut layer and not dry through, bottom and top coating are not matched 5 Different types of paint on the upper and lower layers are peeling off, base material is not polished 6 Sagging One time thick coating, short recoating time and low paint viscosity precautions: 1 Wood paint shall be painted after the completion of ground construction, and ventilation shall be maintained during construction, without dust, so as not to affect the overall effect Wood paint and emulsion paint cannot be constructed at the same time 2 The wood shall be dry with moisture content no more than 15% The humidity and temperature of the construction environment shall not be too high 3 The paint products are mainly composed of three components (main paint, diluent and curing agent) The paint shall be evenly mixed before mixing The paint shall be prepared in strict accordance with the proportion 4 The diluent and curing agent shall be selected to avoid undercutting and wrinkling 5 After mixing, the paint shall be filtered, and the paint can be painted only when it is still for 10-15 minutes 6 One time construction coating shall not be too thick, and the next layer construction shall be carried out after the coating is dry 7 It shall be thoroughly and fully polished until the whole paint film feels smooth and flat, so as to avoid poor adhesion between layers As a result, the home of starting coating is focused on coating, diatom mud, paint coating materials, coating technology, fire-resistant coating news information and coating, diatom mud, paint coating, coating technology, Decoration knowledge and effect drawing of fireproof coating,