Common operating instructions for the cooling and heating device of the reactor

When the reaction kettle is equipped with a cooling and heating device, the material runs and reacts in the reaction kettle, and the evaporation and reflux of the reaction solution can be controlle.
After the reaction is completed, the material can be discharged from the discharge port at the bottom of the kettle, which is convenient to operat.
The power supply voltage of the heating and cooling device of the reaction kettle must be consistent with the provisions of the instrument, and it is not suitable to run at high speed with no loa.
Please keep the governor and motor dr.
The heating and cooling device of the reactor is installed first, and then the electrician is wired and energize.
The ground terminal must be grounde.
The high temperature bath must be connected to the air switch, and the reactor is equipped with a cooling and heating device to cut off the power supply within 5 minutes, due to the discharge of the inverter or capacitor, there may still be electric shoc.
When the reaction kettle is equipped with a cooling and heating device, pay attention to the impact damage to the glass by the hard objects on the body, and pay attention to the impact damage to the glass by the hard objects on the body during operatio.
Be careful when connecting the heating and cooling device of the reaction kettle to the vacuum pipe and water pipe, so as to avoid damage to the human body from breaking the glass with excessive forc.
When a high-temperature circulating oil bath is required for the cooling and heating device of the reactor, pay attention to the damage caused by high temperature to the human bod.
Special attention should be paid to the high temperature cycle, the circulating pump should be turned on first, and the temperature of the heat-conducting solvent should be slowly increased while the heat-conducting solvent is running and circulatin.
When using the heating and cooling device of the reactor, it is necessary to pay attention to its us.
Try to choose the heating and cooling device of the reaction kettle of the brand manufacturer, and take explosion-proof measure.
The heating and cooling device of the reactor is used with various reactors for cooling, heating and temperature control, so the user still needs to understand the instructions for the cooling and heating device of the reactor before us.