Common problems and solutions of pillow packing machine

Pillow type packaging machine is developed for the re packaging of aluminum-plastic drug plates in the pharmaceutical industry, which improves the moisture-proof performance of the packaged aluminum-plastic drug plates, and can play a role of light proof for drugs The equipment adopts PLC programmable controller to make the whole machine run programmatically, and is equipped with automatic coding function to print the production batch number, production date, expiry date and other words on the outer package Pillow type packaging machine is equipped with automatic feeder which can be used for various specifications of aluminum-plastic medicine plate, and a full-automatic folding device is innovatively designed, so that the packaging objects with certain thickness can be folded and packed neatly and beautifully Here is a brief introduction to the common problems and solutions of pillow packaging machine, as follows: 1 The speed is too fast, the inner layer of the coating has poor heat sealing performance, and when the temperature is too low, the sealing will be leaky or insecure The maintenance method is to slow down the speed, adjust the temperature, and replace the thin film materials 2 When the cutterbed is too high or too low, the packaging speed is too fast, and the push rod is not synchronized with the cutter, the maintenance method for the cutter to cut on the product is to reduce the packaging speed, adjust the height of the end sealing parts, and make the cutter center in the middle of the product height 3 If the air pressure is not correct, the cylinder swing rod is loose, the heating temperature is low, and the hot press roll is not parallel to the transmission roll, the poor heat sealing will occur The maintenance method is to adjust the parallelism, adjust the temperature and air pressure to make it tight 4 The solid-state breaker is burnt out, the temperature control meter is damaged, and the temperature meter cannot control the temperature when the thermocouple is damaged The maintenance method is to replace the electric couple, the temperature control meter and the heating body 5 When the temperature is too high, the speed is too slow, and the heat resistance of the outer layer of the coating is poor, the way to repair the traces of wrinkles on the seal is to adjust the speed, reduce the temperature, and change the film material 6 The color of the film color mark is too light, the film drive slips, and when the color mark tracking is not turned on, the cutting position will deviate from the color mark At this time, the maintenance method is to refer to the packaging machine manual and adjust its sensitivity; in the human-machine dialogue interface, switch the tracking mode to "tracking cutting".