Correct operation and maintenance of digital display constant temperature water bath

 How to use the digital display constant temperature water bath: 1.
Warm water must be added to shorten the heating time and save electricity
.

2.
Turn on the power switch, the power indicator light on means the power is on
.

3.
Set the meter to the required temperature, the heating indicator light is on, it means that the power supply of the electric heating tube is turned on for heating, when the temperature on the thermometer reaches the required temperature, after a few minutes, it will be automatically controlled by constant temperature
.

4.
The scale of the thermostatic controller is only used as a temperature comparison indication, not a temperature indication scale.
Maintenance and repair of the digital display thermostatic water bath: 1.
Turn off the power supply after use
.

2.
The inside and outside of the box should always be kept clean
.

3.
If it is found that the instruction light is not on, first turn off the power supply, unplug the plug and disassemble the right plug board, if the fuse or indicator light bulb is damaged, it can be replaced with the same specification
.

4.
If the thermostat control fails, it means that the sensor on the controller is out of order, and it can be used after replacement
.