Correct operation of labeling machine

All motors of the labeling machine can be adjusted, and the stepping motor has been adjusted since it was delivered from the factory, so it will not be adjusted in general The speed of the adjustable speed motor can be adjusted according to the production speed of the label and the length of the label The speed regulating knob is installed on the control switch box There are four speed regulating motors in the machine, i.e paper feeding motor (stepping motor), main conveying motor, label tape rolling motor, bottle distance adjusting motor (bottle manager is installed according to the user's requirements, so it is not listed here) Adjust the speed relationship between the four motors to obtain the ideal labeling effect Now the adjustment procedure is described as follows: First, check the operation of the motor separately, calibrate the labeling machine to the horizontal position, plug in the main power supply, press the motor buttons respectively, adjust the corresponding knobs of the three speed regulating motors on the control box, so that they can coordinate with each other, and take the level of the label stickers as the standard In the future, it is basically unnecessary to adjust the knob, as long as the machine is turned on, it can be produced The speed control knob and switch button of each speed control motor are marked with words on the electrical control box How to adjust the operation process of the labeling machine: 1 First loosen the fixing screws on the reel, remove the plexiglass tray, and then adjust the position of the back tray so that the position of the back tray can meet the requirement that the reel is at the center line of the paper tape After fixing the screws, install the paper tray 1 and the plexiglass front tray, and then fix them with screws After that, check whether the rotation of the web tray is flexible (the pressing block should be loosened at that time) If it is not flexible, further adjust it according to the above steps until it is flexible 2 Requirements for wearing label paper tape: first, check whether all rollers on the label paper tape route are flexible If they are not flexible, they must be adjusted until they are flexible The threading method shall be carried out according to the red line direction on the view, and special attention shall be paid to the passage of the labeling paper tape in the space of the photoelectric sensor to ensure the normal operation of the photoelectric transmitter   3 Test labeling: put the bottles to be labeled on the conveyor belt, adjust the left and right bottle bars, close to the label rolling device, adjust the front and back up and down distances, press each motor switch button, and then start two sets of photoelectric switch buttons, first put several bottles into the test labeling, and check whether the labeled paper meets the required requirements, then it indicates that the test labeling stage is passed and can be entered Line mass production 4 In case of any accident during commissioning and production, the operator can press the emergency stop device 5 In case of broken bottle glass or sundries during labeling, stop the machine immediately, and continue production after cleaning 6 Shutdown: when it is necessary to stop production, turn off all switches first, and then turn off the main power supply.