Correct use and maintenance of K-type reciprocating feeder (coal feeder)

K-type reciprocating feeder (coal feeder) is a complete and normal working coal feeder (reciprocating feeder) composed of connecting rod crank shell, bottom tug, coupling, coal feeder floor and other parts The coal feeder starts from the manufacturer and finally arrives at the designated place after a long journey During the initial stage of installation and long-term non-stop operation, we need to use and maintain it correctly to achieve the long-term normal operation benefits We need to pay attention to the following points: 1 The K-type reciprocating coal feeder needs to be tested for 2 hours without load after installation, and the rolling bearing needs to be tested for 2 hours The temperature rise shall not be greater than 600C 2 When adjusting the feeding capacity, pull out the pin shaft at the crank position, loosen the nut and turn the crank; the transmission parts and reducer shall be maintained and cleaned after 6 months of continuous operation, and the rolling bearing and box body shall be replaced with worn parts 3 Select and fix according to the position "1, 2, 3 and 4" of the crank housing, insert the pin shaft, and fasten the pin shaft and nut 4 During the operation of the coal feeder, sufficient coal quantity shall be stored in the coal bunker to avoid direct impact on the bottom plate when the coal is loaded into the bunker; the lining plate for direct friction between the parts and the coal shall be replaced when the thickness of the lining plate is more than half worn 5 The transmission parts and reducer shall be overhauled and cleaned after 6 months of continuous operation, and the rolling bearing and box shall be replaced with worn parts The motor and reducer shall be maintained as required K-type reciprocating feeder (coal feeder) models are: K0, K1, K2, K3, K4 The larger the model is, the greater the motor power is, but the use and maintenance are the same Please keep in mind during use.