Correct use of pharmaceutical low temperature heating unit

The pharmaceutical low temperature heating unit is suitable for the equipment connected to the reaction device for refrigeration and heating reaction in the pharmaceutical and chemical industries
.


1.
Regardless of whether it is air-cooled or water-cooled, the all-in-one temperature control device must be located in an operating environment with sufficient space: the surrounding space should be greater than 30cm
.

2.
When choosing a heat transfer medium, pay attention to its upper and lower limits of temperature, whether its ignition point, viscosity, freezing point, etc.
meet the requirements, and whether it is suitable for the use of the internal pipes of the instrument; 3.
When choosing a refrigerator to transmit heat transfer medium, the length should be as long as possible It may be short, and the diameter should be as large as possible.
If the diameter is too small, it may cause current limiting
.

4.
Improper heat transfer medium will have a negative impact on the instrument and equipment, and may cause damage to the device
.

Therefore, only the heat transfer medium specified by the manufacturer can be used and used within the specified pressure range
.

The temperature can only be controlled below the boiling point of the heat transfer medium
.

When filling the thermal medium, it should be poured slowly, carefully and steadily, while ensuring that no thermal medium overflows
.

 　　5.
After filling, reset the adjustment parameters of the pharmaceutical low-temperature heating unit, which is the requirement for correct operation and use of the instrument
.

 　　The working principle of the pharmaceutical low-temperature heating unit is to drive the heat transfer medium through the pump, from the fuel tank equipped with the built-in heater to the temperature control equipment, and then from the temperature control equipment back to the fuel tank
.

The controller adjusts the temperature of the thermal fluid according to the temperature of the thermal fluid measured by the temperature sensor or the internal temperature of the temperature control device, thereby adjusting the temperature of the temperature control device
.

 　　The pharmaceutical low-temperature heating unit is a temperature control machine that can complete both heating and cooling.
It can realize mutual switching, speed up production progress and reduce energy consumption.
It adopts computer touch control and automatic calculation function.
Customized according to customer's needs
.