Dabao can electrostatic spray water-based single component transparent primer

with the country's environmental protection requirements more and more stringent, as well as the public awareness of environmental protection, resulting in more and more strong demand for environmental protection products, water-based wood paint market share is also increasing year by year, at present in all the single-component waterwood paint, static spray waterwood paint utilization and efficiency is relatively high, its utilization rate is 2 times gas spraying, so can improve the operating environment, reduce environmental pollution and reduce the cost of coatings and labor costsDabao can electrostatic spray single-component waterwood transparent primer components by water-based resin, physical pigments, water, film additives and a variety of additives, because it is a multiphase system, the composition is more complex, after a reasonable formulation design and production process settings, can be perfect construction results and coating conditionsGeneral air spray single-component waterwood coating in the use of electrostatic spraying (DISK line spraying), coating film will appear more defects, such as bubbles, particles, orange peel, poor leveling, flow hangingand the sticky disk phenomenonThe main reason for these defects is the difference between electrostatic spray line and gas spray, which needs to be adjusted to adapt to electrostatic spraying in order to achieve good construction resultsstatic spray water-based single-component woodsolid transparent primer CW-321 (CWF-321) features:1, excellent anti-flow hanging and levelingBecause water-based electrostatic spraying is usually dropped, is basically spray, and spraying viscosity is relatively low, resulting in easy flow hanging, CW-321 (CWF-321) by adjusting the thickening system can achieve electrostatic spraying, paint film perfect leveling and anti-flow hanging2, fast polishingIn electrostatic spraying, the general product online time is relatively short, which requires that the product must be able to achieve a short period of drying after the effect of non-stick sand, this mainly by selecting a reasonable resin and solvent, while zinc powder should also be incremental to solvethe most important advantage of this product is to adapt to the electrostatic spraying process, the use of electrostatic spraying process, the above characteristics are more prominentcoating process reference:white body sand, back cover, sand, CW-321 (CWF-321) sand, sand, CW-321 (CWF-321) , supporting static spray paintnotenote:1, the use of electrostatic spraying, the adhesive degree of the paint should be adjusted appropriate, not too high, so as not to occur in the case of a sticky disk2, after the completion of the first paint film, do not be afraid of heavy sand, so as not to paint film sand broken, the back coating will appear a rib gin situation