Detailed explanation of the disassembly and installation of the main parts of the small single punch tablet press

It is suitable for laboratory trial production or small batch production of various tablets, sugar tablets, calcium tablets, special-shaped tablets, etc It is a small table type electric (manual) continuous tablet pressing machine, which is equipped with a pair of stamping dies, and the filling depth and tablet thickness of materials can be adjusted We can provide all kinds of molds according to customers' requirements Instructions for disassembly and installation of main parts of small single punch tablet press: 1 Disassembly of middle mold platen: take out the powder baffle, take down the hopper, screw out the fastening screw of feeder, screw down the fixing stud and spring of feeder, take down the feeder, screw down the fixing screw and spring washer of middle mold platen, and then take down the middle mold platen Installation: refer to the reverse order above Pay attention to alignment when screwing on the feeder fastening screw To avoid damage to the feeder screw hole 2 Disassembly of the upper punching core rod: loosen the lock nut of the connecting rod, turn the upper punching core rod to separate it from the connecting rod, turn the hand wheel to raise the eccentric wheel housing to the Zui high position, and turn the eccentric connecting shell to swing the connecting rod to the front upper part, then the upper punching core rod can be pulled out from the upper part of the mold base hole Refer to the reverse order for installation 3 Disassembly of lower punch core rod: unscrew the lower punch fixed screw, butterfly screw and gear press plate to turn the adjusting gear, so that the lower punch core rod can be lowered and taken out from the bottom hole of the machine body Installation: refer to the reverse order above 4 Disassembly of connecting rod: first remove the upper punch core rod, then remove the steel wire retaining ring on the connecting rod pin, take out the connecting rod pin, and then remove the connecting rod Installation: proceed in reverse order 5 Disassembly of large belt pulley, pinion and bridge shaft: press down the V-belt, screw down the right end nut and washer of bridge shaft (in the body), hold the large belt pulley firmly by hand, pull out together with the pinion and bridge shaft, and then pull out the bridge shaft from the wheel hole (the big belt pulley, the pinion and the shaft sleeve are pressed together Generally, they do not need to be disassembled.) Installation: refer to the reverse order above 6 Disassembly of main shaft: two persons shall be responsible for the disassembly of main shaft First remove the large pulley, then screw down the nut to remove the lever, lever shaft and filling roller (if necessary, remove the hand wheel and filling CAM) remove the protective cover, screw down the screw and washer, and knock the non working surface inside the big gear with a wooden hammer (not important) Remove it (pay attention not to lose the lifting roller), knock the shaft end with a wooden hammer and a copper rod (pay attention not to damage the screw hole at the shaft end), hold the other end of the shaft and hold the eccentric wheel shell, and slowly remove the main shaft Installation: refer to the reverse order above.