Discussion on the adjustment of sheet output and filling of single punch

The special tools used for adjusting the output of the single punching machine are: socket wrench and paddle (1) turn the driving hand wheel by hand to make the lower punching rod rise to the Zui high position, loosen the locking screw on the nut seat, and rotate the nut with the paddle to adjust, so that the tough mouth of the lower punching rod head is flush with or slightly lower than the upper surface of the middle die hole, so as to ensure that the lower punching rod can smoothly push the tablet out of the middle die hole, and tighten the locking screw on the nut seat ② rotate the driving hand wheel for two or three cycles, and the upper surface of the lower punch head is still flush with or slightly lower than the upper surface of the middle die hole, then power on: ③ power on the empty car for more than ten cycles, and the machine operates normally, then the chip adjustment is qualified Loosen the locking screw by hand, turn the filling hand wheel clockwise (mark the "+" direction), the filling amount increases, and the weight of the tablet increases: turn the filling hand wheel anticlockwise (mark the "-" direction), the filling amount decreases, and the weight of the tablet decreases; after the adjustment, tighten the locking screw.