Do you know the seven points of attention for differential pressure density meters?

Do you know the seven points of attention for differential pressure density meters? The two probes of the differential pressure online density meter are under the liquid level of the measuring medium, and the maximum flow rate is below 2m/s
.

If the medium is corrosive, the wetted part and diaphragm should be made of anti-corrosion material
.

Taking into account whether the components will be corroded by corrosive gases or process exudates, the filling liquid may leak and cause contamination of the measurement medium, and an appropriate filling liquid should be selected
.

The following are the precautions for differential pressure densitometers, let's take a look
.

The main precautions for the online density meter XF-MD3051 are: 1.
Handle with care to prevent touching or squeezing the pressure-sensitive diaphragm
.

2.
The liquid level of the measured medium should exceed the two pressure-sensitive diaphragm positions
.

3.
The online density meter is installed vertically, and the inclination cannot exceed 5 degrees
.

4.
During measurement, there should be no thick sedimentary layer in the tank, so as not to affect the measurement
.

 　　5.
When the conventional density meter is in use, avoid contact with the corrosive or overheated medium to be measured
.

 　　6.
The measured medium is not allowed to freeze, otherwise the sensing element will be damaged, resulting in damage to the sensing element of the density meter
.

 　　7.
The online density meter should be installed as far as possible in a place with small temperature steps and temperature changes, without shock and vibration, to ensure the accuracy of the measured value
.

 　　The above is an introduction to the precautions for differential pressure density meter.
I believe that everyone has a corresponding understanding of this after reading, and I hope it will be helpful to everyone
.