Do you understand the precautions in the cleaning process of ultrasonic bottle washer

Cleaning process of ultrasonic bottle washer: the bottle is put into a special parallel plate, which is composed of a bottle plate and a cover plate, and is separated and positioned by a bottle plate with Confucius It is manually sent to the * station, after the circulating water is sprayed and injected into the river, it sinks to the ultrasonic tank for ultrasonic rough cleaning; then the bottle plate rises and pushes into the second station, and the outer bottle is washed with the water spray facing down, the needle is inserted into the bottle (air flushing), the first cleaning (water for injection), the second cleaning (water for injection), the third air flushing, drying, the bottle mouth up, and automatically enters the sterilization oven The vibration plate of ultrasonic bottle washing machine can be controlled by PLC program The air source is purified compressed air, the washing water in the bottle is injection water, and the outer wall and ultrasonic initial washing water are circulating water Operation process and precautions for cleaning antibiotic bottles with ultrasonic bottle washing machine: 1 First, put the antibiotic bottles into the buffer turntable, and then turn the bottles upside down into the cleaning track During the turning process, operate carefully and slowly to avoid the breakage of the antibiotic bottles 2 Place the ultrasonic transducer about 20 mm away from the bottle, because this position can make the cleaning effect of the antibiotic bottle Zui better, and completely immerse the ultrasonic transducer in the ultrasonic cleaning tank before cleaning 3 A low drainage position of Zui shall be set in the ultrasonic cleaning tank to ensure the complete discharge of residual water, and the surrounding of the cleaning tank shall be wrapped tightly to prevent water leakage 4 In addition, a protective device shall be set in the ultrasonic cleaning to prevent the falling of debris and overflow of water, and the water tank for rough cleaning must be opened and placed with the water tank for fine cleaning to prevent confusion during operation 5 Before the antibiotic bottle is put into the buffer plate, some space should be reserved for easy operation When the antibiotic bottle is put into the buffer plate, Zui should operate it manually and directionally 6 In the cleaning process, ensure the speed of the rotary table is stable, and ensure that the bottles can pass through smoothly and evenly at each bridge, so as to prevent the antibiotic bottles from falling down due to too fast speed or chaotic handover 7 Since it is impossible for each bottle to be exactly the same, in order to prevent the work termination caused by the failure of a slightly wider bottle in the cleaning process, Zui has set up a device to facilitate the passage of all bottles 8 If conditions permit, Zui is able to set up a device that can turn the bottle automatically and let the bottle in and out automatically, because avoiding manual operation can reduce the error rate and damage rate 9 After finishing the cleaning process, turn the cleaned antibiotic bottle over again, make its mouth upward, and enter the oven track in a bacteria free environment When the following conditions occur, the ultrasonic bottle washer and the circulating pump will immediately stop operation and give an alarm: 1 When the slightly wide bottle cannot pass the operation track; 2 When the ultrasonic bottle washer has mechanical failure; 3 When too many antibiotic bottles are placed, the machine cannot work normally; 4 When the water vapor pressure at the cleaning point is lower than the fixed value.