Fault service precautions and maintenance methods for 3D motion mixers

Three-dimensional motion mixer is a mixer, the machine's mixer multi-directional movement, materials without centrifugal force, no partial gravity and stratage, accumulation phenomenon, each group can have a wide weight ratio, mixing rate of more than 99.9%, is currently a variety of mixing machines in a more ideal product.
equipment is suitable for high uniformity mixing of powdered and granular materials in pharmaceutical, chemical, food, light industry, electronics, machinery, mining and metallurgy, defense industry and scientific research units.
the following small editor a brief introduction to the three-dimensional motion mixer fault repair precautions and maintenance methods, as follows: 1, found that the fault should be repaired in a timely manner.
control parts should be kept clean and sensitive.
2, should clean up the residual material in all parts of the machine, after the end of use.
three-dimensional motion mixer mixer mixer mixer emulsifying machine deactivation time is long, it is necessary to wipe all the machine clean, the surface of the machine is coated with rust-proof oil, with a poncho cover.
3, such as the discovery of 3D mixer vibration abnormal or make abnormal sound, during use.
should stop immediately for inspection.
4, stirring slurry should be removed lightly, steadily installed, lightly released, so as to avoid deformation damage.
5, 3D motion mixer reducer must be replaced every three months with new oil, often used.
the gearbox should be cleaned and added with new oil when replacing.
6, the inspection site for snail wheels, worms, bearings, oil seals, machine parts regularly check 1-2 times a month.
the operating parts are flexible, whether the fasteners are loose, found abnormal conditions should be dealt with in a timely manner.
three-dimensional motion mixer maintenance: 1, installation: the three-dimensional motion mixer placed smoothly, installed feet, flat, so that the machine can run freely.
2, 3D sports mixer before use will need to refuel, and then carry out empty operation, check whether the fasteners are loose, electrical is normal, machinery is operating normally, if there is an abnormal, repair and commissioning.
3, the feeding port to the above, open the feeding cover for feeding, the amount of feeding can not exceed the prescribed volume, and then close the feeding cap, start the machine to run, if found abnormal, must stop inspection.
4, after-hours or changing varieties must be rinsed inside and outside the 3D sports mixer thym.