Fully automatic softening water equipment relative to standard workflows increases the salt water re-injection process.

The relative standard workflow of automatic softened water equipment will increase the salt water re-injection process, Chongqing Volan water treatment detailed introduction for you: softening water equipment standard workflow mainly includes: work (sometimes called water production, the same below), rewashing, salt absorption (regeneration), slow flushing (replacement), fast flushing five processesAll processesdifferent softening water equipment are very close, but there may be some additional processes due to different actual processes or the need for controlany softening water equipment based on sodium ion exchange is developed on the basis of these five processes (where fully automatic softening water equipment increases the salt water re-injection process)fully automatic softening water equipment re-washing: after a period of work softening equipment, will intercept a lot of dirt brought by raw water in the upper part of the resin, these dirt removed, ion exchange resin can be fully exposed, the effect of regeneration can be guaranteedthe reverse wash process is when water is washed in from the bottom of the resin and flowed out of the top, so that the dirt that was intercepted from the top was washed awaythis process usually takes about 5-15 minutesfully automatic softening water equipment salt absorption (regeneration): the process of salt water injection into the resin tank, traditional equipment is the use of salt pump to inject salt water, fully automatic equipment is the use of a dedicated built-in injector to draw salt water (as long as there is a certain pressure in the water can be)fully automatic softening water equipment in the actual work process, salt water at a slower rate flow through the resin regeneration effect is better than the effect of simply soaking resin with salt water, so deionized water equipment is using salt water slow flow through the resin method regeneration, this process generally takes about 30 minutes, the actual time is affected by the amount of saltautomatic softening water equipment slow flushing (replacement): after flowing with salt water through the resin, with raw water at the same flow rate slowly rinse the salt in the resin all wash clean process called slow flushing, because there are still a large number of functional groups on the calcium and magnesium ions on the sodium exchange, according to practical experience, this process is the main process of regeneration, so many people call this process replacementthis process is generally the same as salt absorption, i.eabout 30 minutesfully automatic softening water equipment quickly rinse: in order to completely rinse the residual salt, to use the actual work close to the flow rate, with raw water to the resin flushing, after this process water should be the soft water to meet the standardin general, the quick flushing process for softening water equipment is 5-15 minutes.