How to carry out daily maintenance on the capsule filling machine

It is very important to use the capsule filling machine correctly, and the daily maintenance of the capsule filling machine is also important So how to carry out the daily maintenance of the capsule filling machine? 1 This equipment is a vibrating machine The fastening condition of screws at all parts shall be checked frequently If it is loose, it shall be tightened in time to prevent failure and damage 2 The plexiglass parts (worktable board and medicine board) shall be protected from direct sunlight and near high temperature, and heavy objects shall not be used The medicine board must be placed vertically or horizontally to avoid deformation and damage 3 The electrical shell and body must be grounded to ensure safety and cut off the power after work. 4 At the end of every day's work, the residual drugs on the machine and in the mold hole shall be cleaned to keep the whole machine clean and sanitary and avoid washing the machine with water If the mould on the machine needs to be cleaned, the fixing screw can be loosened, and then it can be taken down, which is convenient for installation Common faults and maintenance of capsule filling machine 1 The vibration is not ideal, adjust the voltage 2 The spring screw is loose and tightened 3 The capsule shell is arranged in the working platform plate, with the mouth higher or lower Adjust the height of the dislocation plate and the guide rail 4 The capsule shell has too many inverted heads (more than 3%), and the vibrator is not adjusted properly Because the proper voltage is adjusted or the capsule shell size is not up to the specification, the qualified capsule shell is selected 5 The capsule shell can not fall when it is stuck on the platen Replace the capsule shell or adjust the position of the dislocation plate and platen hole 6 The mold cannot be reset in the track, and the compression spring at the back end of the track is stuck or the capsule variant is stuck Reinstall the spring or ejector rod, and push the stick to push the stuck capsule down 7 The guide plate in the mold is worn, which affects the low rate of capsule fitting Replace the new mold or loosen the positioning on both sides, fasten the positioning nails, change the capsule shape or wet, and replace the capsule shell