How to repair some common faults of eye drops filling capping machine?

Eye drops filling capping machine in the operation process will more or less have some failures, even if the good equipment, long use, or improper operation, in the production process will also fail
.

Common fault repair methods of eye drops filling capping machine: 1, such as micro switch or photoelectric switch drift leads to automatic switch failure, you can adjust the working position of the position switch or photoelectric switch or replace the switch
.

2.
The starting current caused by the short circuit of the motor level winding and the shell, and the short circuit of the electric actuator wiring and the ground wire
.

This fault can check the motor on the one hand, and check whether the relevant wires are loose on the
other hand.

3.
The acceleration overcurrent fault caused by the short acceleration time setting of the automatic capping machine and the electric shock capacity exceeding the capacity of the inverter can appropriately extend the value setting time, and the capacity of the electric actuator cannot be changed arbitrarily
.

4.
If the voltage in operation is too high due to the excessive change of the supply voltage, it can be easily solved
by entering the power supply into the reactor or appropriately reducing the power supply voltage.

Basic operation of eye drops filling capping machine: 1, the adjustment of the wire roller: put the bottle on the stand, lift the holder to a high point
.

Release the lock nut and adjust the roller so that the edges of the two rollers (with springs) are at the beginning of the
bottle.

Then loosen the lock nut and adjust the adjustment screws so that the edges of the two rollers touch the cover
.

It is advisable
to lock the nut with a little pressure.

2.
Cap lock: loosen the jacking screw, remove the cap head, and then remove the entire lock
.

Install the appropriate plastic lock on the cone sleeve and adjust the lifting height of the bracket to meet the requirements of
the job.

3, the adjustment of the lock wheel: adjust the two lock wheels, first release the lock nut, adjust the lock wheel, so that the edge of the two lock wheels and the lower edge of the bottle cap contact, and then lock the nut (Note: the adjustment should be from loose to tight, while pulling the lock).


4, height adjustment: start the machine to lower the bracket, and then put the bottle on the bracket, release the brake nut, pull the adjustment screw to raise the bracket, and then adjust the appropriate distance
between the cap and the cap.

Screw cap head (generally adjusted in place at the factory
).

5.
Adjust the tightness of the cap: by adjusting the torque between the screw head and the spinning machine, the tighter the cap, the tighter the torque, the tighter
the torque.