How to use and maintain the automatic filling machine

The automatic filling machine adopts touch type human-machine interface, Chinese display As long as it operates according to the instructions on the display screen, it can be easily put on line without any experience, greatly reducing the training time, setting the production speed at will, automatically adjusting the production speed, and cooperating with the speed of any production line for effective production operation Use and operation methods of automatic filling machine: 1 Before starting the automatic filling machine, check whether the disinfection liquid level, power supply and air pressure are normal; check whether the solenoid valves and air cylinders are in good condition by manual method; check whether the action is normal; check whether the turning direction of each water pump is correct; check whether the air is exhausted If abnormal conditions are found, troubleshooting is required before production 2 During the production of the automatic filling machine, it will automatically wash, disinfect, fill, cover and gland without human interference, but the operator shall closely observe the status of each part, if any problem is found, the operator shall timely turn the automatic to the manual to prevent accidents When the chain position is wrong, push out the spindle manually, and then push the chain to the normal position The disinfectant should be added in time to prevent the pump from idling and burning the seal when there is no water 3 After the production of the automatic filling machine, the residual liquid in the pipeline shall be discharged, the gas path and water source shall be cut off, and the power supply shall be turned off Routine maintenance methods of automatic filling machine: 1 We must check some parts regularly and check them regularly Inspection parts include: worm gear, worm, bolts on lubrication block, bearings and other movable parts Check whether these parts rotate flexibly and wear If any defect is found, repair it in time and do not use it reluctantly 2 The automatic filling machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other corrosive gas circulation to the body 3 After the automatic filling machine is used, it should be cleaned and installed properly, so as to prepare for the next use 4 If the drum moves back and forth during operation, please adjust the screws on the front bearing pawn to a proper position If the gear shaft moves, please adjust the screws at the back of the bearing frame to a proper position, adjust the clearance so that the bearing does not make any noise, and the hand pulley is properly tightened If it is too tight or too loose, the machine may be damaged 5 If the packaging equipment is not used for a long time, the whole body of the automatic filling machine must be cleaned, the smooth surface of the parts shall be coated with antirust oil and covered with a cloth If the equipment is not used for a long time, check whether all parts are normal before use.