How to use glue in high temperature instant

Instant glue, also known as quick-drying glue or transient dry glue, is the general market 502, transient dry glue can solve a lot of temporary object fixation, why is it temporary, because instantaneous glue is not waterproof, in the daily use of transient dry glue bonding, if long-term contact with water, it will be easy to fall off, re-bonding long-term touch water will also fall off again. Non-wet, water-resistant, brittle, heat resistance is not high enough is its disadvantage. High temperature-resistant instantaneous glue temperature range is about -50 to 100 degrees C, special instantaneous dry glue can reach about 120 degrees C in an instant

.
use of high temperature-resistant instant adhesives
Transients are divided into low-altinized transients, high-temperature transients, rubber toughened transients and general purpose transients:
.Low al-bleaching transients are commonly used for precision instrument bonding and do not bleach after curing.
.High temperature transients are commonly used to bond substrates with operating temperatures above 80 degrees C.
.Rubber toughened transients are commonly used for bonding rubber substrates to improve impact resistance after bonding.
.Universal transients are widely used, as long as there is no long-term contact with water, a variety of materials can be bonded.
The use of high temperature instantaneous glue has the following:
First, before using transient adhesive adhesive products, you must first use dry cotton cloth or sandpaper to remove dust, oil, rust, etc. on the bonded surface, and then wipe with thinner to clean the surface to be bonded.
second bottle of quickener can be used simply by unscrewing the front cover. If you want to control the flow of glue, you can put a needle or PE dropper after use, to ensure that the glue uniform and bonding effect.
a small drop of transient adhesive on the surface to be bonded and secured until the glue cures. The curing time depends on the type of glue. The thinner the layer, the higher the strength, and it is best to apply some pressure before it is fully cured to make it cured better.
the fourth use, clean the bottle port and tighten the lid, such as the surface of the adhesive white, can be removed with cotton cloth or methamphetamine. Store the glue in a cool, dry place after use. Do not place in a place where the sun shines directly.