Installation instructions for small spray dryer

The small spray dryer is reasonable in price and suitable for drying of heat sensitive substances, such as biological products, biological pesticides and enzyme preparations Because the materials sprayed are only subjected to high temperature when sprayed into small particles of fog, it is only transient heat, which can keep these active materials to remain intact after drying The feed volume can be regulated by the feed pump The whole spray drying process of Zui is carried out in glassware The operator can see clearly that if there are any problems, it can be adjusted in time The inner wall of glassware is treated with antistatic treatment, so dry powder will not stick to the inner wall under normal dry conditions The small spray dryer price supplier talks about the installation of spray dryer: 1 the installation of the drying room, holding the drying room with both hands, then slanting into the fixed clamp of the drying chamber, and locking the drying chamber to lock the nut (the drying chamber can be turned in the clamp) 2 For the installation of the cyclone separator, insert the lock nut, sealing ring and stainless steel gasket of the cyclone separator into the air outlet pipe of the cyclone separator, and then insert them into the air outlet pipe of the equipment together Adjust the position of the air outlet of the drying chamber and the air inlet of the cyclone separator to make the two ports straight and aligned Connect the two ports with clamps After Zui, lock the lock nut of the cyclone separator 3 Connect the aggregate bottle and cyclone separator with clamps 4 Connect the aggregate pipe and drying chamber with clamps 5 install the spray chamber on the equipment, connect the 4mm trachea (needle for use) and 6mm trachea (spray) 6 install the food grade silicone tube to the peristaltic pump and insert the spray chamber feed port.