Instructions and maintenance of sugar coating machine

Operation instructions and maintenance of icing machine: 1 Operation instructions 1 Carefully check whether the wiring is correct 2 Turn on the power supply and check whether the rotation direction is consistent with that required by the pot head 3 Before starting the machine, first turn the combination switch, press the main motor button to make the main motor run, turn on the power switch of JZT controller, and then slowly adjust the knob At this time, the speed of the speed regulating motor should gradually rise, and then adjust the speed to a certain value to stabilize 4 When the machine is shut down, the controller power can be cut off first, then the motor power, or both power can be cut off at the same time 5 If periodic oscillation is found during operation, the two wires of the magnetic coil can be interchanged on the terminal block 2 Use and maintenance 1 Loosen the nut on the right side of the body to adjust the dip angle of the coating pot, which is convenient for handling materials and cleaning 2 The electric appliance ensures that the cold and hot air are controlled separately and the air supply volume is adjusted The knurled nuts on the hot air tank can be loosened and the fingers of the blades can be turned downward 3 Loosen the two knurled screws or nuts on the heating furnace frame to adjust the position of the furnace 4 Change the oil for the reducer every 6 months, and pay attention not to block the air outlet on the top cover III maintenance and safety technology 1 The lubricating oil in the gearbox and the lubricating grease in the inner cavity of the rolling bearing shall be replaced regularly 2 If the sugar coated pot is not used for a long time, it should be wiped clean, and its surface should be coated with oil to prevent the copper material of the pot from oxidizing or generating toxic copper compounds after being damped 3 In order to ensure the lubrication conditions of the worm gearing in the reduction gearbox, the temperature rise of the gearbox during operation shall not exceed 50 ° C 4 The oil proof sealing ring at worm shaft end shall be inspected and replaced regularly (generally no more than six months) 5 The machine must be reliably grounded, and its grounding resistance shall be ≤ 4 Ω 6 Do not remove the electrical appliance and belt protective cover at will.