Key factors of increasing equipment output by dewatering screen

The dewatering screen is produced in accordance with jb2444-86 "ZSM block type double shaft vibrating screen for briquette" It can be used for coal preparation, beneficiation, power generation, sugar production, salt production and other industrial departments to carry out dry and wet screening, dewatering, demineralization and desliming of medium and fine-grained materials In addition to the material and structure, Zui's concern is the output, and he will also say that what he bought before can't reach the output Why? In general, Jinhe machinery can process 30-300m3 of materials an hour in the production of linear dehydration screen, but some customers report that sometimes the equipment he purchased deviates from the actual output Due to different manufacturers, the equipment produced will also be different, and there are many reasons that affect the output To increase the output, the following should be done: the key factor for dehydration screen to increase the output of the equipment: 1 Daily maintenance: regularly add grease and ensure the cleanness of the oil chamber Before starting the machine, check whether the links of all parts are loose and ensure the stability of operation At the same time, pay attention to monitor the sound of the machine If there is any abnormality, stop the machine for maintenance in time 2 Mud content of bluestone: in the recovery of bluestone, if the mud content is too high, the output of equipment in unit time will be reduced, the consumption of vulnerable parts will be accelerated, and the user investment will be increased 3 Vulnerable parts of equipment: hammer head is the main consumption part of high-frequency linear dehydration screen, which should be regularly maintained and replaced during operation If the loss is serious, it will have a great impact on the output and discharge particle size of the reclaimer 4 Feed particle size: the feed particle size of the high-frequency linear dehydration screen is ≤ 350mm If the feed particle size is too large or the content of large-size material is high, the output of the recovery system will be reduced, and the hammer head, hammer shaft and other damages will be greater Features of the dewatering screen: 1 The vibrating motor of the dewatering screen is convenient to replace The rubber spring of the base is used for damping, so that the vibration amplitude is small and the vibration is slow, and the dewatering screen can be removed cleanly 2 It can be customized according to the output and water content The side plate of the fuselage has a reinforcing plate, the bottom is equipped with a support, the bottom is equipped with a horizontal bar, the outlet is equipped with a triangular steel plate support, and the plate is thick 3 The vibration motor is fixed with high-strength bolts, and the bottom spring is a rubber spring The quality of the spring will affect the life of the vibration motor The fixed density of the sieve plate is high, and there are reinforcing ribs in the sieve plate 4 After welding, the welder will strictly avoid welding holes, and the bottom will be supported by channel steel 5 In addition, the mesh can be adjusted according to the needs, the equipment noise is small, and the dehydration effect is good 6 Before delivery, the staff will debug it, check whether the vibration motor is normal, and whether the exciter is in good operation, so as to ensure the quality of products for customers 7 Added value of dewatering screen: for products with low mud content, the dewatering screen can also be used directly without the use of sand washing machine, which saves the cost of customers and achieves the same effect.