Maintenance method of pill making machine for traditional Chinese Medicine

The pill making machine of traditional Chinese medicine is mainly used for pill making of traditional Chinese medicine It can produce dense pill, concentrated pill, watertight pill, coating, drying and pellet products produced by food processing The machine adopts high-precision mechanical transmission mode It can be processed continuously and automatically (or manually) Circular, flaky and strip products needed for the production of traditional Chinese medicine, health care and food industries Using thermoelectric drying process, the finished product is coated / sugar coated for drying Maintenance methods of traditional Chinese medicine pill making machine: 1) lubrication and replacement of bearings of traditional Chinese medicine pill making machine After every 300 hours of operation, the bearing shall be cleaned If the bearing is lubricated by engine oil, when adding new engine oil, it is better to fill 1 / 3 of the clearance of bearing seat, with Zui no more than 1 / 2 Before operation, just tighten the cover of the regular cover type oil cup a little When the bearing of the crusher is seriously worn or damaged, it shall be replaced in time and lubrication shall be strengthened; if tapered roller bearing is used, the axial interval of the bearing shall be checked to keep it at 0.2-0.4mm, and if there is any discomfort, it can be adjusted by increasing or decreasing the paper pad at the bearing cover 2) replacement of claws and hammers In the grinding parts, the grinding claw and hammer piece are the vulnerable parts in the feed crusher, and also the main parts that affect the grinding quality and productivity The grinding claw and hammer piece should be replaced in time after being worn When replacing the tooth claw, the disc should be pulled out first Before pulling out, first open the round nut lock on the back of the disc, screw out the round nut with a hook wrench, and then pull out the disc with a special puller In order to ensure the running balance of the rotor, the complete replacement should be paid attention to when changing the teeth, and the static balance test should be done after the replacement to make the crusher work stably When assembling the toothed claw, it is necessary to tighten the nut and pay attention not to omit the spring washer Qualified parts shall be selected during gear change, and the weight difference of single claw shall not be greater than 1.0-1.5g 3) repair and replacement of screen The screen is made of steel sheet or sheet iron When the screen is worn or broken down by foreign matters, if the damaged area is not large, it can be repaired by riveting or soldering; if the large area is damaged, it should be replaced with a new screen When installing the screen, make the burred side of the screen hole face in and the smooth side face out, and the screen plate and screen frame shall be closely fitted During the installation of the ring screen, the stubble of the overlapping inner layer shall follow the rotation direction to prevent the material from sticking at the overlapping position