Operating procedures for general electric water distiller

(1) Close the drain cock first, and then the cooling water will enter the condenser from the water inlet control cock, and then flow into the funnel from the return pipe and into the evaporation pot, When the water level rises to the glass mirror, the water tap can be closed temporarily (2) when connecting the power supply, it is necessary to see whether the voltage is consistent with the rated voltage of the product, connect the ground wire, and then turn on the power for heating (3) When the water in the pot is boiling and the distilled water begins to flow out, turn on the water tap However, it should be noted that the cooling water should not be too large or too small The temperature of the cooling water can be adjusted by testing the temperature of the shell of the cooler by hand; the temperature at the bottom is 38-40 ℃ (micro temperature), or the temperature at the middle is 42-45 ℃ (hot), or 50-55 ℃ (hot) It should be (4) the condenser is made of metal material Therefore, after about 10-16 h and pre evaporation, the distilled water can be used only after passing the inspection The distilled water can be used only after pre evaporation for 30 Zui before each use (5) Before use, clean the inside once a day, drain the water, and replace the fresh water to avoid scale and reduce the water quality (6) regularly clean the scale on the wall of the boiler, the surface of the electric heating pipe, the inner wall of the cooler shell, the outer wall of the condensation pipe, etc but pay attention not to scratch the tin coating on the surface (7) The distilled water pipe should not be too long, and should not be inserted into the distilled water of the container Keep the downstream flow unblocked to prevent funnel overflow caused by steam smothering (8) the heating element of the distilled water heater is the immersion type electric heating pipe The structure of the utility model takes the nickel chromium alloy wire as the heating main body, which is buried in the center of the copper tube, and the surrounding is filled with magnesium oxide as the insulation Because the melting point of nichrome alloy wire is much higher than that of copper tube, when the water is cut off, the heat it emits cannot be absorbed by the water, so the shell of copper tube is quickly melted Therefore, the electric heating pipe is forbidden to be used in water Shangyu Star Instrument Equipment Co., Ltd is located in Daoxu Town, Shangyu District, Shaoxing City, Zhejiang Province It is an enterprise integrating production, product development, processing and trade The company's main products: drying box series, incubator series, laboratory muffle furnace series, distiller series, as well as clean workbench, air shower room, ventilation cabinet, biosafety cabinet and other complete sets of purification equipment The company has a strong technical research and development team, a strong after-sales service system, is the leading manufacturer of complete set of laboratory equipment in China, welcome customers to buy.