Operation method and notes of triangle bag packing machine

I preparation of triangle bag tea packaging machine: 1 Clean the dirt, sundries and other articles on the machine, and clean and disinfect all parts contacting with food 2 Check whether all screws are loose during transportation Turn the belt by hand for a week, check whether the machine is stuck and does not rotate, if so, find out the cause and eliminate it 3 Add lubricating oil (36 × oil) to the guide post of transverse seal, cam, discharge clutch and other moving parts Check whether the gearbox is short of oil If it is lower than the center line of the oil tank, please add 36 × oil A) connect the power supply and close the leakage switch in the electric control box B) set the required temperature of the longitudinal and transverse sealing mould, and let the temperature on the temperature control meter rise to the required temperature of the packaging material II Starting sequence: jog the packaging machine for trial operation Turn the discharge clutch handle to the disconnection mark No abnormal start of the machine idling 1 Adjust the stepless governor to Zui slow position according to the mark 2 After the machine is shut down, the packaging material is sent to the longitudinal sealing mold along the formator according to the steps in the membrane drawing diagram, and the sealing is inched, the paper pulling clutch is disengaged with the right hand, the membrane is pulled to the paper pulling wheel with the left hand, and the paper pulling clutch is closed 3 Start the empty bag of the packaging mechanism and check the sealing quality 4 Close the blanking handle and observe whether the blanking time is correct 5 Pour a small amount of materials into the barrel, start the packaging machine, test the finished products, and check whether the packaging weight meets the requirements 6 Batch production of finished products can only be carried out after the above preparations are completed III shutdown sequence: disconnect the blanking clutch → press the stop key to stop → disconnect the main power switch → clean and clean IV precautions for the triangle bag packaging machine: 1 The operator must be proficient in the operation process according to the above sequence, otherwise it may cause machine failure 2 During the operation of the machine, pay attention to whether the sound of the machine is normal, whether the temperature is normal, whether the packaging film is used up, and whether the materials are used up Operators shall not leave the packaging machine in the production process, and stop the machine for inspection in time in case of any problem 3 Remember the original size and position when adjusting each mechanism, so as to restore to the original starting point when the adjustment is not ideal Running in of new machine must be operated at Zui slow speed for 100-150 hours