Precautions for cleaning antibiotic bottles with ultrasonic bottle washing machine

Precautions for cleaning antibiotic bottles with ultrasonic washing machine operation process and precautions for cleaning antibiotic bottles with ultrasonic washing machine: 1 First, put the antibiotic bottles into the buffer turntable, then turn the bottles upside down and put them into the cleaning track In this turning process, operate slowly and carefully to avoid the breakage of antibiotic bottles 2 Place the ultrasonic transducer about 20 mm away from the bottle, because this position can make the cleaning effect of the antibiotic bottle Zui better, and completely immerse the ultrasonic transducer in the ultrasonic cleaning tank before cleaning 3 Set a low drainage position of Zui in the ultrasonic cleaning tank to ensure the complete discharge of the remaining water, and wrap tightly around the cleaning tank to prevent water leakage 4 A protective device shall also be set in the ultrasonic cleaning to prevent the falling of debris and overflow of water, and the water tank for rough cleaning and the water tank for fine cleaning must be opened to prevent confusion during operation 5 Before the antibiotic bottle is put into the buffer plate, some space shall be reserved for easy operation When the antibiotic bottle is put into the buffer plate, Zui should conduct the operation manually and directionally 6 During the cleaning process, ensure the speed of the rotary table is stable, and ensure that the bottles can pass through the bridge in a balanced and smooth way, so as to prevent the antibiotic bottles from falling down due to the speed is too fast or the handover is chaotic 7 Since each bottle cannot be the same, in order to prevent the work termination caused by the failure of a slightly wide bottle in the cleaning process, Zui has set up a device to facilitate the passage of all bottles 8 If conditions permit, Zui should be able to set up a device that can turn the bottle automatically and let the bottle in and out automatically, because avoiding manual operation can reduce the error rate and damage rate 9 After the cleaning process is completed, turn the cleaned antibiotic bottle over again, make its mouth upward, and enter the oven track in a germ free environment When the following conditions occur, the ultrasonic bottle washer and the circulating pump will immediately stop operation and give an alarm: 1 When the slightly wide bottle cannot pass the operation track; 2 When the ultrasonic bottle washer itself has mechanical failure 3 When too many antibiotic bottles are placed, the machine cannot work normally; 4 When the water vapor pressure at the cleaning point is lower than the fixed value