Precautions for the maintenance of label labeling machines

There are many equipment in the packaging equipment, and the labeling machine is one of them, which is the equipment
that pastes the paper gold on the specified packaging container with a foil label or adhesive.

Among them, the common faults of the labeling machine are as follows: 1.
Turn the rotary hub to the appropriate position, push the clamp index to the optimal position inward, and tighten the
bolt.

2.
Bottle spiral misalignment
.

Use a wrench to loosen the fastening bolt, rotate the helix to adjust to the optimal position, first tighten one bolt, jog to observe the effect, and tighten the other bolts
after the position is suitable.

4.
The inkjet code is not clear, and the position is not centered
.

Check the cap for foreign matter or water droplets and adjust the position of the blow pipe; Check whether the nozzle is clean and rinse the nozzle; Adjust the nozzle position so that the spray code is centered
.

3.
Marking board residual standard paper
.

It is possible that the clip finger is loose, adjusting the position of the clip marker; The glue is too large, adjust the glue temperature; Taking less glue from the left side of the standard board causes the standard paper to warp, and adjust the position
of the standard board.

5.
The amount of glue pumped is small or blocked
.

Check the bottom of the pump for debris blockage; Check for foreign body blockage inside the hose; Check the position of the steel balls and whether the pump is leaking
.

6.
Flick the bottle
during operation when the top label is attached.

Check whether the ball in the bottle head is missing, resulting in inflexible bottle rotation, replace it; Check whether the high and low position of the bottle head is suitable and adjust its position; Check that the backplane behind the bottle is in place at the transfer hub feed, and then make adjustments
.