Precautions when using concentrator

Precautions when using the concentrator: 1 Check whether the ore pipe or groove, overflow port are unblocked, rake is in good condition, underflow gate should be opened and closed freely, and close tightly (there should be spare gate); 2 Check whether the rubber pump screw is loose and triangle belt is loose; 3 Clear the sundries on the upper part and around the machine, and check whether there are obstacles on the rack and raceway The transmission part and lubrication parts shall be in good condition and shall not be operated with faults; 4 Check the condition of roller screen for screening particles The above four points are confirmed to be correct before start-up; 5 Close the underflow gate, start-up with no load, and then feed the ore; 6 No sundries are allowed to fall into the machine, and the underflow ore drawing gate must be opened flexibly and equipped with a standby gate; 7 Check the operation of the thickener center and drive each rubber pump The leakage of packing ore shall be treated in time, and the lubricating part shall be filled with oil in time; 8 The safety device shall be kept and the signal shall be in good condition; 9 The tailings shall be treated before the stop, the load shall be reduced as much as possible, and the ore drawing gate shall be closed; 10 The sundries and equipment in the ore feeding channel shall be cleaned and the warning signs shall be hung to ensure civilized production;