Product description of capping machine

Adjustment of the upper arm of the electric Capping machine when rolling bottles of different specifications The machine can be used for rolling 5-500ml bottle caps When using any of the bottles, just put the bottles of this specification on the tray, hold the cross arm with one hand, and loosen the nut on the left side of the cross arm with the other hand, so that the cross arm can be lowered or raised until the capping head and the bottle cap are positioned about 20mm, tighten the nut, and then use the Allen wrench with the machine to close the supporting ring to the cross arm and then put the supporting ring Lock (Note: pay attention to the alignment between the capping head and the bottle cap during tightening.) Adjust the V-shaped support block of the electric Capping machine, put the bottle into the lower V-shaped support, unscrew the two screws on the support block, move the bottle and the lower V-shaped block together until the position of the capping head and the cap is aligned, and then tighten the two screws on the V-shaped block Specific operation method of electric Capping Machine 1 Put the bottle filled with liquid and put the lid on the lower tray, lean on the V-shaped support block, hold the bottle with one hand, and tighten the handle backward and downward with the other hand At this time, the tray lifts the bottle with the support of the bottle until the bottle cap and capping head are pressed tightly 2 When the bottle cap and the capping head are pressed tightly, the three continuously rotating capping heads rotate for several turns, and then the bottle cap is pressed tightly (note) the motor must run clockwise 3 Push the handle forward to make the cover return to the original position along with the tray, and the whole operation process is completed Repeat the above operation for each bottle cover in the future Adjustment of capping head of electric Capping machine the machine is equipped with multiple capping heads, which can be selected according to the size of different bottle caps Try it with a bottle before use 1 If the cover is not tightly rolled, unscrew the lock nut of the cover head, screw out the upper cover head in a counterclockwise direction, and then lock the fixed nut 2 The cap is too tightly rolled and there is a phenomenon of screwing off the cap The lock nut of the upper rolling cover head can be unscrewed and screwed into the upper rolling cover head in a clockwise direction, and then the fixed nut can be locked 3 The lower edge of the bottle cap is not tightly tightened, and the eccentricity of the three rolling heads can be properly reduced according to the actual situation If the retraction is too tight and there is bottle crushing phenomenon, the eccentricity of the three tool heads can be properly adjusted.