Selection and purchase of diatom mud: Sao nianlang, accept the dry goods! Construction method of diatom mud fabric texture pattern

Core tip: how to make the fabric texture pattern of meimeida diatom, a small editor will teach you 1 If the wall surface is dry, the water shall be rolled twice before construction 2 The first batch of diatom mud shall be applied to ensure the flatness of the wall 3 When the wall is half dry (not sticky), apply diatom mud for the second time Instructions: (Process Guide: the first batch is flat (coated with a thickness of sand) After a little drying, it can be applied second times (thin coated with a thickness of sand) With a spatula, the residue is collected and the surface is leveled Until the hands are lightly pressed, they are basically not touched Paint knowledge how about Akzo Nobel Powder Coating Recommended introduction: powder coating is a kind of coating with different form from general coating, which is in powder form It is a new type of coating, because of its own advantages and more and more known by people Let's introduce Akzo Nobel Powder coating Akzo Nobel Powder coating is a cost-effective coating solution, which can be applied to different kinds of products After the treatment of static electricity and fire baking, a tough and durable coating surface will be formed, with the least impact on the environment Since the introduction of this technology, powder coating has been able to continue to maintain the Home of paint news: how to make the fabric texture pattern of meimeida diatom mud, I will teach you 1 If the wall surface is dry, the water shall be rolled twice before construction 2 The first batch of diatom mud shall be applied to ensure the flatness of the wall 3 When the wall is half dry (not sticky), apply diatom mud for the second time Instructions: (Process Guide: the first batch of flat (thin coating with a thickness of the sand is the most accurate), then it can be applied second times (slightly coated with a thickness of sand) after a little drying, and then use the spatula to collect residue and surface Until the hands are lightly pressed, basically do not touch hands, then use the foam board to gently draw the wire horizontally (sand scraping), and then gently pull the wire (scraping sand) with foam board Sometimes it may be because the surface is dry and uneven, and the drawbench (scratching) texture is not clear enough to use the foam board to add wire drawing (scraping) until the texture is uniform Wait for a moment and use the leveling trowel to slightly level it, with less force Wait for a while and then use the finishing spatula to flatten once with slight force After drying for a while (subject to no obvious water light reflection on the surface), the protective tape can be torn off and the edge of the construction surface can be leveled Construction tools: foam board (8cm suitable), ordinary spatula, wet towel, flat top spatula coating house is focused on coatings, diatom mud, paint and coatings, coating technology, fire retardant coatings news information and coatings, paint and coatings, coating technology, fire retardant coatings decoration knowledge and decoration effect map.