Teach you to solve electronic scale failure in ten minutes

As we mentioned earlier, electronic scales are used in more and more industries, so what should we do if there is a failure? Below for you to talk about the electronic scale in general will appear several kinds of faults and solutions *This kind of fault is common in Zui, that is, the screen display of the electronic scale is abnormal What are the reasons for the abnormal display? There may be the following kinds: if there is a word break in a single font, it may be poor LCD contact, unclear fault display or failure to display, it may be electronic component fault For the above reasons, my advice to you is to find the repair department or the manufacturer who bought the scale to let them repair it The second kind of fault, no action after the electronic scale is turned on (this fault often occurs when we use the electronic scale), so what is the cause of this fault and what should we do? The first thing to think about is whether the scale has no power If it has no power, please charge or replace the battery as soon as possible (for the scale using dry or battery) If the scale using aptor is connected to the output end of the aptor of the scale, look and pull it out, and then install the dry battery If it can be started, that is, adptor is damaged, then replace the aptor Check whether the fuse is in poor contact Consider whether the power on or the key may be damaged, and the electronic components may fail In case of any fault, it is recommended to send it to the maintenance department for repair or purchase the manufacturer for repair If the above reasons are not the same, it is recommended to send them for repair The third kind of fault is that the scale is not allowed to check whether the switch protection device is removed Please re calibrate according to the calibration steps in the product manual If not for the above two reasons, it is recommended to find the maintenance department for repair or purchase the manufacturer for repair Fourth, the scale can't backlight? Check whether the backlight function of the internal program of the electronic scale is set (refer to the product manual when setting) If the backlight function is set, the scale plate needs to be placed on the weighed object (9 times of the sensitivity can be lit above) to check whether the electronic components are in fault If there is a fault, it is recommended to find the maintenance department for repair or purchase the manufacturer for repair If none of the above reasons are true, it is also recommended to send it for repair The fifth kind of fault, the electronic scale can not scale to the full load? Consider whether the scale protection screw is removed Check whether there is any foreign matter in the electronic scale, which may cause interference, impact and falling injury Whether the internal program setting of the electronic scale is correct (please refer to the operation manual for setting) If it is caused by item 2 or not, it is recommended to send it for repair.