The correct use of automatic pill making machine for traditional Chinese Medicine

(1) check whether the wiring is correct before startup A, B and C are phase lines and N is zero line 2 Check whether the oil level of each part of the whole machine meets the lubrication standard 3 Check whether the electric control system is normal 4 Check whether the pushing system is installed correctly and concentric 5 Check whether the shot making knife of the shot making system is aligned and fastened 6 Check whether the automatic control system is sensitive and reliable 7 Check whether the flow of alcohol system is normal, whether there is alcohol leakage, and whether the outflow of alcohol mouth is consistent 8 Check whether the heating system is heated 9 Whether the ground wire is secure （2） Start up and run 1 First press the main power start button, the whole machine is powered on, the rotating pusher runs and rotates, and the H1 table shows the pusher running speed Thruster operation Press the pill rolling operation button, the pill rolling motor starts, then press the pill cutting start button, and adjust the running speed at the same time Table H2 shows the working voltage of the pill cutter motor 2 After the pushing, rolling and cutting operation is normal, evenly add the charge into the charging box, extrude the charge from the exit of the strip under the rotary extrusion of the propeller, and then send the charge from the bottom of the automatic control wheel to the guide wheel to make the charge enter the pill making knife 3 The automatic control system is used According to the strip speed of the drug, adjust the pill cutting adjusting button to the speed slightly higher than the strip speed The automatic control wheel controls the matching of the strip speed and the pill making knife speed, so as to complete the automatic control 4 Adjust the alcohol to the non stick knife, the smaller the alcohol, the better.