The organization of industrial temperature control cold and heat circulation device

Industrial temperature control cold and heat circulation device is composed
of compressor, condenser, expansion valve, heat exchanger, temperature controller, circulation pump, pre-cooling unit, heating unit, refrigeration unit and other accessories.
Each part has its own role and advantages
.
When the space is relatively small, the operating power of the equipment can be appropriately reduced, and the operating power of the appropriate high and low temperature cooling and heating system group can be selected, which reduces the probability of equipment failure and helps to extend the service life
of the equipment.
The industrial temperature-controlled heat and cold circulation unit works by a pump that drives the heat transfer medium (usually water or oil) from the water tank equipped with a built-in heater and cooler to the reactor and then from the reactor back to the tank
.
The controller regulates the thermofluid temperature and resolves the reactor temperature based on the thermal fluid temperature measured by the temperature sensor, or/and the internal temperature
of the reactor.
Industrial temperature control cold and heat circulation device also has some special models, such as isolation explosion-proof, one drag two, one drag more, etc.
, each has different characteristics, you can choose a specific model
according to your own needs.
Of course, you can also choose a special model to meet your own requirements
.
Choosing the right laboratory reactor high and low temperature all-in-one machine can not only be put into use quickly, but also will not cause waste
.
The industrial temperature control cold and heat circulation device is installed inside the reactor by the temperature sensor and set on the control panel, showing that the temperature reactor temperature is consistent, which is suitable for situations where
the temperature control accuracy is high.
At present, PID control technology is used to compensate for various factors
affecting reactor temperature.
Heating power, medium circulation pressure and flow
rate should also be considered when choosing.
The industrial temperature-controlled cold and heat circulation device is composed
of a refrigeration circulation system, a heating circulation system and an automatic control system.
For areas where the equipment has explosion-proof requirements, the positive pressure explosion-proof box can be customized to not only meet the explosion-proof requirements, but also reduce the use of explosion-proof components and reduce the production cost
of the whole machine.