The precautions before and after the installation of the double purification table should not be taken lightly

Precautions before and after the installation of the double purification table should not be taken lightly The double purification table provides an operating environment with a cleanliness level of 100, horizontal laminar flow pattern or vertical laminar flow pattern
.
Using a thin barrierless air filter, which occupies little space, and adopts a touch electronic control panel, the fan air volume can be steplessly adjusted to ensure that the wind speed in the working area is always in an ideal state
.
Stainless steel work table plexiglass can be equipped with UV lamp remote control electrical interface
.
How should the double purification table be protected? 1.
Check and unplug the power plug
during maintenance.
2.
In order to maintain the technical performance of the work table, the start setting, daily operation and protection and maintenance of the equipment are very important.
If these matters are taken lightly, the performance of the equipment will be reduced, so that the work table will operate
in a flawless state.
3.
The dense to the livestock operation table adopts a structure
in which the positive pressure polluted area is all surrounded by the negative pressure area.
4.
Moreover, before sterilizing the working table with formaldehyde fumigation, in order to avoid formaldehyde leakage, the "soap bubble" method should be used to check
the sealing of the whole machine.
What are the precautions before and after the installation of the double purification table? 1.
Before the installation, point the new filter to the bright place to see with the naked eye whether the filter shows loopholes due to transportation and handling, etc.
, if there are loopholes, it cannot be used
.
2.
When installing, pay attention to the arrow mark on the filter because the direction of the wind outlet of the work platform is consistent
.
3.
When
tightening and pressing the gong nail.
Apply force evenly
.
That is, to ensure that the fixing and sealing of the A device is stable and stable, and to avoid the deformation of the A device and cause leakage
.
4.
After replacement, the dust particle counter should be used to detect the leak, especially around the filter frame for scanning and viewing
.