The trouble of the packing machine and the way to solve it

The packer is also known as the bundling machine One of the following is the troubleshooting methods of the packer Condition 1: the belt is not cut after the bundling There are many situations that can cause this situation: 1 The tension adjustment is too tight; 2 There is oil in the slip sheet or the slip belt, which are all located near the tension adjustment The oil must be removed and wiped off 3, the belt is too tight, reduce the belt drive seat down, or adjust the motor back 4 Use a thinner belt or take off roller with too much clearance Condition 1: strap handling When the strap is stuck in the middle of the roller, or there is foreign matter that cannot be taken out, the handling method is as follows: 5 Remove the washer of the hex nut 6 Loosen the two M5 countersunk screws on the middle connecting shaft Since these two screws are fixed on the gap part of the connecting shaft, the screws must be turned up 7 Remove the connecting shaft, pick up the upper engine and take out the stuck object 8 Assemble and restore according to the above c-b-a method 9 Pay attention to the clearance condition of 0.3-0.5mm between the nut and L-shaped curved plate 2 The bonding effect is not good 1 The temperature is too high or not enough, sometimes it is a special belt with poor viscosity The temperature must be very accurate 2 The voltage used is not enough There are many factories with insufficient voltage If the extension cable or cable is used again, the voltage drop will be caused, so that the original adjusted temperature will become low, or even the motor will burn when it is tightly tied Therefore, try to avoid using the cable If it is necessary to use the extension cable, it is necessary to connect the thicker but not too long wire 3 The 635 bearing under the middle knife is broken, so it is heated and cannot be bonded completely 4 The long pull spring on the electric crank (swing bar) is tired, so that the crank cannot be pulled to the position, resulting in half or even less adhesion 5 The electric heating steel sheet is too high and too low, or it is inclined to the left and right, so it meets the PP belt at the top and bottom, or the left and right cutting tools, and cannot enter the heating, so it shall be adjusted according to the situation 6 The failure of the exhaust fan caused the temperature to be too high