What are the environmental requirements for the normal operation of the full-automatic pelletizer?

The work of the automatic pill making machine is relatively simple It mainly uses its own sharp knife, which is cut by some traditional Chinese medicine under the working state you set, so the more important care for it is transferred to the care of the knife In fact, we need to start from your initial choice, because some pill making machines are steel knives and some are iron knives I think you can understand which is not easy to be corroded without saying, so the choice becomes very important Secondly, we need to clean it in time after our daily work to ensure that there is no risk of blade corrosion in the next work Of course, it is not enough to only care for the blade We should also take effective care of its body Because some medicinal materials contain water, it is inevitable to splash on the body during the cutting process Therefore, for the sake of safety, it is recommended to clean the body of the full-automatic pill making machine Only in this way can we make the loss smaller The full-automatic shot making machine is suitable for indoor environment with temperature from - 5 ℃ to + 40 ℃, relative humidity less than 90%, voltage amplitude fluctuation less than 10% of rated value, no conductive dust and corrosive metal gas around It can be installed in the plant with sufficient sunlight and clean, without foundation, and it can be leveled For safety, it must be grounded Before starting the machine, it is necessary to check whether the oil level of the gearbox reaches the standard position; check whether the oil cup on the hopper is filled with edible oil; check whether the pelletizer is aligned and tightened; check whether the wine cleaning system is smooth, and adjust appropriate amount Use alcohol to disinfect guide wheel, guide frame, pill making knife, etc Turn on electric heating The striping part shall be idled for 3-5 minutes If there is no abnormality, the material can be fed and the striping can be pushed out Return to a part of the hopper, and open the pelletizing part after the strip is qualified The feeding shall be uniform during operation If it is found that the sliver and pill making are not synchronized, it can be adjusted by the knob The pill making is fast in clockwise direction and slow in anticlockwise direction.