What are the main stages of operation of the three-in-one multi-function dryer?

The principle of three-in-one multi-function dryer: This machine is designed as a double conical tank, one end is a filter plate, the other end is a washing and outlet, and the jacket can be heated
by steam or hot water.

The tank is placed on both sides of the
frame via a spindle.

At both ends of the spindle is a steam and condensate interface, through the steam to complete the heating process, the other end is a vacuum port, through the vacuum pump or vacuum system, so that the tank is in a vacuum state, complete the filtration process, and extract the evaporated water vapor
during the drying process.

The motor and the reducer are also placed in the frame, and through the gear transmission, the tank is driven to reverse and the material is constantly turned up and down, inside and outside
.

In the washing process, the material can be fully and evenly mixed to complete the washing process
thoroughly.

In the drying process, the heating surface can be continuously replaced to make the material heated evenly and achieve the purpose of
balanced drying.

The operation of the three-in-one multi-function dryer mainly goes through the following stages: 1.
Reaction and concentration stage: With the end of the stirring facing down, the mixing leaf form can be selected according to various materials
.

In the upper inlet of the equipment, the material is introduced, and the material reacts and concentrates
by the continuous turning of the stirring blade.

2.
Filtration stage: rotate the cone 180 °, with one end of the filter disc facing down, connect the vacuum port at the bottom of the end body, and separate
the product filter cake and the mother liquor.

3.
Washing stage: After the end of filtration, enter the washing liquid, start the stirring leaf, and also rotate the cone at the same time, so that the filter cake is broken and further purified with the washing liquid, and the residual mother liquor is cleaned and dehydrated
.

4, drying stage: after the end of the filtration again, in the vacuum port through the nitrogen backblowing, so that the filter cake and the filter net separated, rotate the cone, in the rotary process by the crusher to break the filter cake, the jacket through the hot water to heat the entire cone
.

And in the vacuum state to make the material to achieve the purpose of
drying.

An in-situ sampling process
can be performed.

Micronizes are captured by a cyclone separator and organic solvents
can be collected by a condenser.