What are the operation methods and precautions of swing granulator

Any machine must follow the correct operation method The same is true for the swing granulator Today's editor will introduce the operation method and precautions of the swing granulator 1 Prepare to check the equipment status identification, equipment operation record, etc before starting up, and confirm that the equipment is in normal operation state Check and confirm that the motor part is safe and reliable with good insulation 2 Check whether the lubricating oil and engine oil in the rotating parts of the machine and the turbine box are above the oil level line If not, inform the workshop equipment management personnel in time to refuel 3 Check the cleanness of the drum, hopper and other parts of the equipment, and carry out necessary cleaning work 4 Check that the specifications of the screen mesh meet the specified mesh number and process requirements, and the width is consistent with the machine body; install the screen mesh, insert the screen mesh meeting the requirements, and tighten the clamp network tube left and right Connect the power supply and press the start button to run the equipment 5 Start up and idle for about 20 seconds If the equipment does not make abnormal sound and the temperature of bearing and reducer does not rise rapidly, confirm that the equipment operates normally After confirming that the equipment is normal, shut down the machine, and press to put the turnover container or install the turnover bag Start the machine again, add materials to the hopper and start granulation 6 Keep feeding continuously, not too much or too little, and keep 2 / 3 volume of the hopper Pay attention to observe particle size and screen wear at any time If screen wear is found, stop the machine immediately for replacement After the operation, turn off the switch and power supply, take out the remaining materials, and clean all parts and periphery of the equipment Precautions for operation of swing granulator: 1 If abnormal vibration or abnormal sound is found in use, stop the machine immediately to check and eliminate the fault 2 The materials shall be added gradually It is strictly prohibited to fill them up at one time, so as to avoid damage to the screen due to too much pressure 3 If it is necessary to shovel and insert the material on the wall of the charging hopper during operation, use the appliance after stopping the machine, and do not use the hand to avoid accidents; 4 If the material is stuck in the drum during operation, stop the machine, shovel it out with the tool, and do not extend the hand into the drum When disassembling the drum, it should be pulled out gently, and do not knock hard, so as not to damage the parts and cause concentric deformation of the two shafts 5 It is forbidden to wash the electrical equipment with water, and prevent the electrical equipment from getting damp when brushing the equipment 6 If the equipment is not used for a long time, all the equipment must be wiped and cleaned, the smooth surface of the parts shall be coated with antirust oil and covered with tarpaulin.