What are the precautions for the operation of the reaction kettle refrigeration and heating temperature control device

In the chemical pharmaceutical and chemical polymer industries, chemical synthesis reactions are often accompanied by endothermic and exothermic reactions, often due to large exothermic heat, large heat absorption and large feedback lag of the reactor itself, resulting in poor temperature control accuracy or out of control.
Cause product quality to be affected or lead to safety production accidents
.

The reaction kettle cooling and heating temperature control device adopts a fully closed circulation system, and there is no oil mist during high temperature operation, which can achieve high temperature refrigeration and high temperature direct start refrigeration control effect.
Fixed cooling or heating temperature requirements
.

For debugging before laboratory operation, operators who need to know the performance of the equipment should first check whether the configuration, installation, foundation and pipeline connection of the equipment meet the requirements
.

Check whether the power supply is reasonable and whether the pipeline meets the experimental requirements
.

After debugging the performance of the equipment, check whether the environmental site is clean, bright and ventilated, and whether each pressure instrument is in normal operation, and then it will be officially put into operation after inspection
.

The models of the reaction kettle refrigeration and heating temperature control devices are large and small, so the laboratory needs to reserve the corresponding position according to the appearance of the equipment
.

It is recommended to place it on a flat ground, and the slope should not be too large
.

There is a wheel under the device to move it
.

If the moving work is over, the wheels of the reaction kettle cooling and heating temperature control device can be fixed
.

There are corresponding passages or spaces around the equipment, and the ground is clean and non-slip, so that the equipment operators can add liquid or perform other operations
.

 　　The cooling and heating temperature control device of the reactor is not suitable to be placed outdoors
.

When installing, it is also necessary to wire according to the manual, pay attention to the power wiring of each electrical component, and select the appropriate wiring connection according to the power supply in the manual
.

After the equipment is connected and powered on, do not disassemble it without authorization, otherwise it will cause the corresponding equipment to malfunction, and in severe cases, the equipment will be damaged
.