What is the installation and cleaning method of oral liquid filling machine?

How to install the oral liquid filling machine is a problem in the minds of many buyers In general, there will be technicians from the filling machine manufacturer to install it in person, but sometimes there will be some special reasons to install it in the evening If the construction period and courage at this time, it will be a bit troublesome In fact, the installation method of the oral liquid filling machine is very simple In a few days, I will give you some details of the installation and the cleaning method of the oral liquid filling machine after the installation Attention should be paid when installing the oral liquid filling machine When unpacking the machine, first of all, check whether the machine is damaged during transportation, so as to solve the problem in time In addition, new lubricating oil should be added to each lubricating point Turn the machine with the crank and check that it is running in the correct direction The operator shall make relevant adjustment before using the equipment In order to adjust the filling component, the filling component allows the liquid to pass through the applicator, the check valve and the needle will be delivered to each easy pull bottle in time, so the needle must be inserted into the bottle correctly "The side convex wheel a can be adjusted to rotate or reverse so that the needle can be inserted into the mouth of the bottle after the empty bottle enters the tooth position and can be easily lifted when the needle leaves According to the equipment personnel, for the adjustment of filling time, cam B can rotate or reverse the adjustable needle to the bottle mouth monkey, start the test tube industry immediately, and stop filling water before the needle leaves the bottle mouth In order to adjust the upper wall, when rolling bottles of different specifications, just put the bottles meeting the specifications on the tray, drag the cross arm one by one, and then loosen the nut on the left side of the cross arm In order to lower or raise the cross arm When the position of the cover and the cover is known to be about 20 mm, tighten the nuts, then use the hex wrench on the strap to tighten the bracket to the cross arm and lock the bracket When the operator wants to adjust the V-shaped bracket, he can put the bottle into the lower V-shaped bracket, loosen the two screws on the bracket, move the bottle and the lower V-shaped block together until the rolling cap and the bottle cap are aligned, and tighten the two screws on the V-shaped bracket During the maintenance of the oral liquid filling machine, attention should also be paid to keep the machine clean No oil, medicine or glass fragments are allowed to damage the machine Therefore, during the production process of the machine, the liquid or glass debris shall be removed in time; all parts of the machine surface shall be cleaned before the shift, and the clean lubricant shall be added to each activity department Clean once a week to clean places that are not easy to clean or blow with compressed air.