Why does the upper cover of the electroplating filter leak!

Why does the upper cover of the electroplating filter leak! The failure of the electroplating filter during use is inevitable, and how to solve the failure is something
we need to consider.
In the daily use of electroplating filters, many customers should encounter such a problem: leakage of the
upper cover.
So today getting smaller and smaller will take you to understand the reasons for the leakage of the upper cover of the
electroplated filter.
When the upper cover of the electroplating filter leaks, it may be caused by the following reasons: 1.
The cover gasket on the equipment is aging after long-term use, loses elasticity, and leads to sealing failure
.
It is recommended to replace the new upper cover seal ring
in time.
2.
Deformation
of the electroplating filter cartridge.
If there is a slight leak, we need to re-correct the upper cover
.
If the leakage is severe, we need to replace the filter cartridge
again.
3.
The handle of the upper cover of the electroplated filter is not tightened, resulting in excessive pressure, it is recommended to lock the handle and clean or replace the filter element
regularly.
In the above, we have increasingly introduced three reasons for water leakage on the upper cover of the electroplating filter, and the corresponding treatment method is also very simple
.
In fact, such failures
can be avoided as long as they are used standardized, regularly checked.
For more details, you can continue to pay attention to the growing pump industry!