Working principle of booster cylinder

The working principle of booster cylinder and the difference between the direct pressure type and the advance type (uPower) introduction of the direct pressure type booster cylinder: the use of the booster is to reduce the space of the accessories on the machine surface, and there is no limitation of directionality, but the piping and working efficiency are relatively troublesome; therefore, under the condition that the space and working direction allow, It is a convenient choice to use the booster cylinder Since the booster cylinder works in the way of converting low air pressure to high oil pressure, and its volume is larger than that of the oil pressure cylinder, it should be used in the design of short stroke work as much as possible Even if such cylinder point is adopted, the direct pressure booster cylinder is still loved by many mechanical designers, It is widely used in various clamping (mold, workpiece), tool changing (cutting cylinder of machining center) and sheet metal processing (circuit board) and other machines Introduction to the pre run booster cylinder: the difference between the pre run booster cylinder and the direct pressure booster cylinder lies in a low pressure pre run stroke Its purpose is the same as that of the supercharger plus a large oil storage tank, but the overall design efficiency is relatively high As long as the space on the machine table allows, it is a good choice for installation and use The supercharger is directly designed at the rear end of the oil cylinder, equipped with the control valve group provided by the company, and connected with the air pressure pipeline, just like the work of the general pressure table