-
Categories
-
Pharmaceutical Intermediates
-
Active Pharmaceutical Ingredients
-
Food Additives
- Industrial Coatings
- Agrochemicals
- Dyes and Pigments
- Surfactant
- Flavors and Fragrances
- Chemical Reagents
- Catalyst and Auxiliary
- Natural Products
- Inorganic Chemistry
-
Organic Chemistry
-
Biochemical Engineering
- Analytical Chemistry
- Cosmetic Ingredient
-
Pharmaceutical Intermediates
Promotion
ECHEMI Mall
Wholesale
Weekly Price
Exhibition
News
-
Trade Service
6.
2.
3.
10 Applicability of the method
Using this method, the eight antibiotics in royal jelly were added at four levels of 1 LOD (2.
0μg/kg), 2 LOD (4.
0μg/kg), 4 LOD (8.
0ug/kg), and 10 LOD (20.
0μg/kg).
, Freeze-dried powder in 1 LOD ( lincomycin , erythromycin , clindamycin , tylosin and josamycin are 2.
0μg/kg, tilmicosin, spiramycin, kititamycin 5.
0μg/kg), 2LOD (lincomycin, erythromycin, clindamycin, tylosin and josamycin are all 4.
0μg/kg, tilmicosin, spiramycin, guitar Both lincomycin, erythromycin, clindamycin, tylosin and josamycin are all 8.
0 μg/kg), 4LOD (lincomycin, erythromycin, clindamycin, tylosin and josamycin are all 8.
0μg/kg, tilmicosin, spiramycin , Kitasamycin are 20.
0μg/kg), 10LOD (lincomycin, erythromycin, clindamycin, tylosin and josamycin are all 20μg/kg, Tilmicosin, Spirulina ( Both 50μg/kg) for four addition levels of kitasamycin and kitasamycin), the recovery rate experiment of adding 8 kinds of antibiotics was carried out, and the analysis results are shown in Table 6-27 and Table 6-28
.
No interference peaks were seen in the peak regions of the 8 antibiotics, and the recovery rate of the samples was between 72.
Table 6-27 Applicability of the method Adding recovery rate (%, n=10)
Table 6-28 Experimental data of suitability of 8 antibiotics in freeze-dried powder (%)
6.
2.
3.
11 Repeatability and reproducibility
Under repeatability test conditions, the absolute difference between the two independent test results obtained does not exceed the repeatability limit (r).
If the difference exceeds the repeatability limit (r), the test results should be discarded and the two individual tests should be completed again.
Determination
.
Under the reproducibility test conditions, the absolute difference between the two independent test results obtained does not exceed the reproducibility limit (R)
Table 6-29 Content range and repeatability and reproducibility equation