What is the operation of stainless steel sanitary centrifugal pump

What is the operation of stainless steel sanitary centrifugal pump? How can the stainless steel sanitary centrifugal pump save energy, emission and energy? It is not only the direction of the country, but also the problem that our enterprises and even individuals should pay attention to So how can we make the sanitary pump (stainless steel sanitary centrifugal pump) run better? The small edition summarizes the following points: 1 The selection of the size of stainless steel sanitary grade centrifugal pump should be used in the area to avoid the waste of large horse pulling car For example, only 3KW sanitary pump is actually needed, and 7.5kW sanitary pump is installed forcibly, which results in large horse pulling car and resource waste Moreover, it is easy to cause overload, air strike and other phenomena, resulting in fatal injury to the pump; 2 Because the operation of stainless steel sanitary centrifugal pump is in a curve mode, with the continuous increase of flow, the head is reduced; at the same time, pay attention to control the fluctuation of the water pressure of sanitary pump to ensure the flow stability, which is more conducive to the implementation of energy-saving technology; 3 Combined with the hydraulic calculation of the pipe network, the stainless steel sanitary centrifugal pump is selected accurately and reasonably to realize the optimization of pump selection and ensure the stable operation in the area When calculating the operation parameters of the sanitary pump, the abrasion of the impeller during the long-term operation of the sanitary pump (stainless steel sanitary centrifugal pump) should be considered to improve the applicability of the safety factor; however, the pump selection should not be too large, otherwise it may cause inefficient operation and increase the energy consumption; 4 If the speed regulating stainless steel sanitary grade centrifugal pump works at rated speed, it shall be at the end of sanitary pump operation Because the selection of speed regulating sanitary centrifugal pump mainly refers to the second flow data, then the working point is the operating point that conforms to the second flow, but the time involved in the second flow in the pipe network is very short, most of the pumps are operating under the condition of lower than the design value If the working point of the pump is at the end of the area, then the pump can achieve stable operation and achieve Zui good energy saving effect 5 The stainless steel sanitary centrifugal pump with high head and low use should be avoided as far as possible If only 10 m head is needed, then a slightly higher head of 10 m should be selected as far as possible If the sanitary pump with high head is not achieved in actual use, it will be used at the low inflection point of efficiency, resulting in waste of efficiency.